top of page

Tombow Glue holder

Updated: Feb 25, 2019

We love making 3D items and we were in need of a glue holder so it would keep our glue upside down so it was ready to go. Obviously, what do we do? We make one! We searched online and did find a lot but decided to use the direction from Stamp with Joy on YouTube. It is relatively simple and can be whipped up in no time at all.


Check out our YouTube Video below with full directions.

For the base you need 8-1/4" x 6-1/4" cardstock. On the long side score at 2", 4", 6" and 8" then switch to the short side at the top of your score board and score at 1-1/2" and 4-3/4". You can decorate your box any way you'd like but we used the How Sweet It Is (of course I had to since it was purple!). You need two of 1-7/8" x 1-7/8" and two of 1-7/8" x 3-1/8"for the outside of box.

When you go to punch the holes for the glue, punch out two circles on scraps using the 1-1/4" punch to use as templates.


Be sure to watch our YouTube and hit the LIKE and SUBSCRIBE button after you are done!



 
 
124026633_661702397826394_52927527782713

kayla & nancy

  • Facebook
  • Instagram
  • Pinterest
  • Youtube
Loyalty Rewards

Join our Newsletter

Purchase a $99 Starter Kit, Select $125 In products

Do you have our 5 FREE Tutorials?

Company

Shop

Promotions

Subscribe to our Newsletter

  • facebook
  • instagram
  • White Pinterest Icon
  • White YouTube Icon

The content on this website is the sole responsibility of Stamping Before Anything Else as Independent Stampin' Up!® Demonstrators. 
Unless otherwise indicated, Images © 1990-2024 STAMPIN’ UP!®.

©2024 by Stamping Before Anything Else, LLC.

bottom of page